Hi Gents,
Thought i would post about adding a Ram Ball Mount to my 1996 ST1100.
When i started this, i was emailing with the USA site, then i found a good Dealer in Australia, Southern Insight, his name is Paul and is a very helpful bloke, he reccomended i go for a handle bar mount rather than a Clutch or brake cap Mount, stronger and not as high was his thoughts.
Southern Insight Pty Ltd
Ph: 1800 441 939
Email: info@southerninsight.com.au
Address:
8 tilley lane
Frenchs Forest
NSW 2086
product information:
i bought a RAM U-BOLT Mount RAM-B-149ZU (mounting Bracket)
and a RAM-HOL-AP6U RAM HOLDER for Apple 3GS iPhone
Total Cost Delivered was: $54.00
in the mail turned up two days later after ordering:

I took it a step further when i got it, i actually took the front bracket off the Clutch Lever bracket, and bolted it on there, and when i did so i ended up with a very ungainly amount of thread showing:

So off to Bunnings i went and found some rubber caps that i cut down to put in between:


and presto it looks 10 times better:

and all mounted up, it looks good, and holds my phone nicely!


all i have to do know is wait for my bluetooth units to turn up and i am onto my next little project