Author Topic: Driveline clunk  (Read 1802 times)

Online Jdbiker

  • NR2024 Rally Team
  • Supreme "2000" Club Member
  • *
  • Posts: 3135
  • Thanked: 1427 times
  • ST Legend
Driveline clunk
« on: July 30, 2019, 08:26:38 PM »
These arrived in the post today from Partzilla ( thanks Alan👍) in less than 3 weeks. Total including post was $283AU. Have been feeling and hearing a distinct clunk when engaging clutch and when accelerating and de accelerating. With the bike on centre stand and in 1st gear wheel has about 2” free travel. With a longish ride coming up in a couple of months I have decided to change out the U joint rather than take chances. Will pull off the swingarm this weekend , will know then if this was needed or just a pointless exercise 😳
« Last Edit: July 30, 2019, 08:34:59 PM by Jdbiker »
Jdbiker.
2008 red ST1300A
1980 Yamaha XS 1100
1974. Yamaha TX 500 sold
1984   Kawasaki GT 750
1975  Honda GL1000 selling

Honda XL 250 sold
Suzuki TS 100
2000 Honda ST1100P
1988 Enfield Bullet 350
 1941 Royal Enfield WD/C 350 engine
2021 Royal Enfield Bullet 500
2024 Honda Transalp coming
 

Offline StinkyPete

  • Defected to a BMW
  • NR2016 Group
  • UNBELIEVABLE "5000 Posts" Member
  • *
  • Posts: 6533
  • Thanked: 2946 times
  • Blackwood, SA
Re: Driveline clunk
« Reply #1 on: July 31, 2019, 07:14:18 AM »
When my "U" joint packed up, I felt it as a buzz through the footpegs, which changed as the bike went over undulations.   See  http://ozstoc.com/index.php?topic=10046.25
IBA #59146   OzLapper 2012 & 2019

Yamaha XS650  (The Black Wobbler)
Yamaha XJR1300 (Rocket Ship)
Honda ST1300 (Beautiful Bike)
BMW R1200RT (Technically Perfect)
 
The following users thanked this post: Jdbiker

Online Jdbiker

  • NR2024 Rally Team
  • Supreme "2000" Club Member
  • *
  • Posts: 3135
  • Thanked: 1427 times
  • ST Legend
Re: Driveline clunk
« Reply #2 on: July 31, 2019, 08:53:21 AM »
Thanks for that Pete. I did read through your post on the subject earlier, hence the reason for my concern, don’t like the prospect of a blown drive line in the middle of nowhere  :eek. I haven’t experienced the buzz you describe but the clunk doesn’t seem normal nor the excessive free travel.
Jdbiker.
2008 red ST1300A
1980 Yamaha XS 1100
1974. Yamaha TX 500 sold
1984   Kawasaki GT 750
1975  Honda GL1000 selling

Honda XL 250 sold
Suzuki TS 100
2000 Honda ST1100P
1988 Enfield Bullet 350
 1941 Royal Enfield WD/C 350 engine
2021 Royal Enfield Bullet 500
2024 Honda Transalp coming
 

Offline West Aussie Glen

  • old fart
  • Supreme "2000" Club Member
  • *****
  • Posts: 3154
  • Thanked: 839 times
  • Willetton, Perth
Re: Driveline clunk
« Reply #3 on: July 31, 2019, 09:29:52 AM »
Shall be interesting to see what you find. How many kms has your bike done?
Glen
Sold
1948 James 98cc 2 Speed, 1969 Suzuki A100-2
1970 Suzuki T250 Hustler, Honda CL100
Yamaha RD250C, 1985 Kawasaki GPZ250
BMW K75S, 78 Yamaha XS11
Yamaha Royal Star Tour Deluxe, 88 GL1500
99 SE GL1500
In the shed
85 Kawasaki LTD250
88 GL1500 Outfit
08 ST1300
2013 GL1800
2013 GL1800 Outfit
 

Online Jdbiker

  • NR2024 Rally Team
  • Supreme "2000" Club Member
  • *
  • Posts: 3135
  • Thanked: 1427 times
  • ST Legend
Re: Driveline clunk
« Reply #4 on: July 31, 2019, 10:20:04 AM »
Almost 90k, will post what I find  :like
Jdbiker.
2008 red ST1300A
1980 Yamaha XS 1100
1974. Yamaha TX 500 sold
1984   Kawasaki GT 750
1975  Honda GL1000 selling

Honda XL 250 sold
Suzuki TS 100
2000 Honda ST1100P
1988 Enfield Bullet 350
 1941 Royal Enfield WD/C 350 engine
2021 Royal Enfield Bullet 500
2024 Honda Transalp coming
 

Online Jdbiker

  • NR2024 Rally Team
  • Supreme "2000" Club Member
  • *
  • Posts: 3135
  • Thanked: 1427 times
  • ST Legend
Re: Driveline clunk
« Reply #5 on: August 16, 2019, 09:33:45 PM »
Took the bike for a spin today  after changing out the U Joint and no more “clunk” :like. However I don’t think the clunk was due to the old U joint as that appears to be in perfect condition with no play whatsoever. On dismantling the swingarm I found the output shaft and drive shaft splines bone dry (u joint end). This I’m assuming was the cause of the clunk noise I was hearing. I measured the free travel at the rear wheel (52mm) before dismantling and that remains the same after changing the U joint. It wasn’t a useless exercise altogether however because there was a slight oil leak at output shaft and swingarm bearings needed lubricating. Seals replaced, joints lubricated and bike running smoothly without clunk  :like
Jdbiker.
2008 red ST1300A
1980 Yamaha XS 1100
1974. Yamaha TX 500 sold
1984   Kawasaki GT 750
1975  Honda GL1000 selling

Honda XL 250 sold
Suzuki TS 100
2000 Honda ST1100P
1988 Enfield Bullet 350
 1941 Royal Enfield WD/C 350 engine
2021 Royal Enfield Bullet 500
2024 Honda Transalp coming
 
The following users thanked this post: Biggles, StinkyPete, ruSTynutz

Offline Biggles

  • NatRally 2018 - Mackay
  • "Top Dog" 10000 club
  • *
  • Posts: 14026
  • Thanked: 2474 times
  • Bridgeman Downs, Brisbane
Re: Driveline clunk
« Reply #6 on: August 17, 2019, 09:11:00 PM »
How hard was the job?
Always a pity if there aren't photos and description, but I fully uinderstand not everyone can put together a "How To" in the heat of the job.
For the modern man who lives in the city, riding a bike might be one of the only ways to escape the humdrum monotony. To take off and ride. To be both at one with nature and one with the bike. To feel masculine. Adam Piggott

OzSTOC #16  STOC #6135  FarR #509  IBA #54927
 
The following users thanked this post: Jdbiker

Online Jdbiker

  • NR2024 Rally Team
  • Supreme "2000" Club Member
  • *
  • Posts: 3135
  • Thanked: 1427 times
  • ST Legend
Re: Driveline clunk
« Reply #7 on: August 17, 2019, 09:57:10 PM »
Not a very hard job, you will need a special tool to remove the pivot bolts or make one like I did . I took my time doing this in the evenings after work , but total time wouldn’t be more than 3 hrs. Hardest bit was trying to locate the boot seal on the swingarm :H. I’ll post a detailed “How To” as best I can when I figure how to post video/pics here👍
Jdbiker.
2008 red ST1300A
1980 Yamaha XS 1100
1974. Yamaha TX 500 sold
1984   Kawasaki GT 750
1975  Honda GL1000 selling

Honda XL 250 sold
Suzuki TS 100
2000 Honda ST1100P
1988 Enfield Bullet 350
 1941 Royal Enfield WD/C 350 engine
2021 Royal Enfield Bullet 500
2024 Honda Transalp coming