Honda ST1300 Section > Seats & Windscreen Modifications ST1300
Sargent - Perth Region
(1/1)
LindsayGT:
Hey,
Does anyone have a Sargent Front seat that I could take a look at, in the Perth Region?
Thanks,
StinkyPete:
I have one, so is Adelaide close enough? If you want to chat about the seat, PM me with a phone number and I'll give you a call. See http://ozstoc.com/index.php?topic=6250.msg70399#msg70399
Since that post I've added a sheepskin cover to the rider's seat.
JC:
--- Quote from: LindsayGT on January 30, 2018, 09:37:42 PM ---Hey,
Does anyone have a Sargent Front seat that I could take a look at, in the Perth Region?
Thanks,
--- End quote ---
Did you get to see a Sargent seat, yet?
LindsayGT:
No!
JC:
Are any close up photos of mine, any use to you?
I rode around Australia on my original ST1300 seat, fitted with an Air Hawk set pad.
This was quite good, comfort wise, but a bit fiddly to get just in the right place, and with the right pressure.
My "2nd hand replacement" (insurance job due to damage caused by third party) ST1300 came with a Sargent seat. It is definitely better than the bare original seat.
I have tried using the Air Hawk pad on the Sargent seat, but with me being 6'2"+ my knees/shins tend to touch the fairing, due to the redesigned seat profile making me lower and further forward, compared to the original.
For comfort and convenience, I use the Sargent seat (by itself) all the time now.
(My wife much prefers the Sargent pillion seat, to the original, too)
Regards
John
:blk13
Navigation
[0] Message Index
Go to full version