OzSTOC
Farkles, Gear & Accessories => Farkles and Gear General Section => Topic started by: Brock on June 12, 2014, 01:34:41 PM
-
There is always a question about whether a gauge is accurate or not. Most tyre gauges are made with a tolerance of +/- 3% of full scale deflection. IE a gauge that has a max reading of 160PSI, can be out as much as +/- 4.8 PSI. The olny way to be sure of your gauge is to have it tested against a Master gauge. (can be expensive)
On the weekend I bought a Motoreyes Digital Pro electronic gauge at Autopro, stated accuracy is +/- 2%. Today I received it back from the Company Cal lab (free cal check). The photo shows the gauge and the test results, very surprising they are, and are good enough for me..
.
.
(http://img.photobucket.com/albums/v235/Avtrician/TyreGauge_zpsbbf37ed4.jpg)
-
I have the same type mine is a Slime brand works well I got mine awhile ago from repco about $20
Turtle
-
That's amazing accuracy! Only 0.5% or less pretty consistently in the range we use.
Just don't drop it!!
Might be interesting to send it back to your mate after a year's use to see how it stands up.
-
I agree with you Biggles, under our QA we have to have our pressure gauges calibrated with a manometer every 6 months. It is amazing how much they drift. We have taken to throwing the gauges out after six months and buying new calibrated ones.
But what do you do? Even 3% error is better than a wet finger in the air.
-
The discussion I had many times at work with the numpties on the hangar floor was some thing like "this gauge is out!!" Me, "How did you arrive at that conclusion??". Numpty " Its 5 PSI higher than that gauge".... "Hmmm, maybe its correct, and the other gauge is out, or they could both be within tolerance..". Numpty "????? How can that be?? " ..... "Well, they are both allowed to be 4.8 PSI either side of the true reading, so one could be a little high, and the other a little low. So really, they are both OK. Bring them to the shop and I can test them. "
Numpty turns up at the Cal lab a week later with a gauge still in the packet " Can you test this??".... Sure, where are the other 2?? ". N "I threw them out cos I couldnt trust them and got a new one." After a quick test on the .1% standard gauge.. " Well there you are, this gauge is good, its 2PSI low over the range, good to go. Here is the cal sticker and the certificate will be on file". N " but its out!!??!! " .... :|||| :|||| :|||| "No, its in tolerance take it and go away"
-
How much was your purchase Brock? I have a pencil type that I used to use on my HR Holden. Should I buy a new one?
-
This cost about $25.00 The connector is double ended, and the tube unrolls from around the gauge. Great for getting in to bike valves and being able to see the result.
-
Yes for sure, but I wouldn't get another Holden! :runyay
-
Yes for sure, but I wouldn't get another Holden! :runyay
Lol. I wouldn't mind getting the last Commodore to roll off the line. No doubt it will become valuable at some stage.