OzSTOC

Honda ST1300 Section => Electrics & Electronics - Volts, Amps and Fuses ST1300 => Topic started by: Simmo50 on July 08, 2018, 03:19:50 PM

Title: abs warning ligbt issues jelp needed
Post by: Simmo50 on July 08, 2018, 03:19:50 PM

have just bought another st 1300 police.  abs warning light was flashing on test ride. had it out for a good ride today and light is staying on permanently.  what are the first tbings i can check   thanks in advance

Title: Re: abs warning ligbt issues jelp needed
Post by: Shillas on July 08, 2018, 06:23:43 PM

Had that problem with my ST1100 after a new front tyre fitted. They didn't bolt the sensor back on properly that time.  So check that it's bolted on and not loose and bouncing around.

Title: Re: abs warning ligbt issues jelp needed
Post by: Brock on July 08, 2018, 09:42:19 PM

Yep, check the sensor clearance. If too far away, the readings will be poor, and too close could cause a damaged sensor.

Title: Re: abs warning ligbt issues jelp needed
Post by: Simmo50 on July 08, 2018, 10:14:42 PM

how do you check the gap.  and what should it be

Title: Re: abs warning ligbt issues jelp needed
Post by: alans1100 on July 09, 2018, 10:27:28 AM

Quote from: Simmo50 on July 08, 2018, 10:14:42 PM

how do you check the gap.  and what should it be

The gap should be in the owners manual which I don't have.

I do have the 2003 1300/1300A workshop manual in PDF and I believe there is one on site if not then I can upload this one.

Air gap is between 0.7 and 1.2mm and you would need a feeler gauge set to check that.

Title: Re: abs warning ligbt issues jelp needed
Post by: StinkyPete on July 09, 2018, 12:09:05 PM

You can download a workshop manual from here   http://ozstoc.com/index.php?topic=407.0 (http://ozstoc.com/index.php?topic=407.0)   and it will have all the info you need.