Honda ST1100 Section > Brakes & Clutch ST1100

1100A Brake Calliper Removal

(1/2) > >>

alans1100:
Need to pick some brain cells here.

We've had our 1100AX for quite some time and I can do most of the sevicable items myself by referencing the manual but this isn't covered in any detail. I need to remove the callipers from the mounts and grease up all the slide pins but nothing in the manual actually states how to do this even when just changing pads. Never had an issue with uneven pad wear until the last pad change even though I could move the calliper freely by hand.

Biggles:
There has to be a first for everything!! Here's Alan needing advice- the chief source of wisdom on the ST1100!
I hope we have someone in the Forum who can help- we owe him about 100+ units of help.
I'm out- sold my ST11 ten years ago.

alans1100:

--- Quote from: Biggles on May 13, 2019, 03:41:46 PM ---There has to be a first for everything!! Here's Alan needing advice- the chief source of wisdom on the ST1100!
I hope we have someone in the Forum who can help- we owe him about 100+ units of help.
I'm out- sold my ST11 ten years ago.

--- End quote ---
Thanks

By the way guess where your 1300 brakes come from.

Brock:
Allan, the mount just slides off, it takes a little effort but isnt hard. The only thing keeping it on if I recall correctly is the little rubber nipples on the end of the slides.

alans1100:
Thanks Brock, I'll give it a go in the morning.

Will start with the LH Front since I don't need to remove that one when doing a tyre change.

Navigation

[0] Message Index

[#] Next page