OzSTOC
Honda ST1300 Section => Honda ST1300 General Questions => Topic started by: zevk on July 07, 2013, 07:44:51 PM
-
I pulled R +L exhaust mufflers off to bench polish and noticed a very small HOLE in the bottom of each can, same location.
2005 ST1300A with 53k stock exhaust.
I have attached photos.
:think1 Question: Is this a "wear spot" and the beginning of pin hole / exhaust rot? >:() If it is Ill dab some exhaust glue / tape, over it
OR, is it an intentional condensation drainage hole? (probably not... :-((()
Do other ST1300 members have the same HOLES?
I can feel, see AND hear exhaust gasses from the small hole.
would appreciate if any member could take a look under your cans and compare. :-++
thanks in advance
Zev
-
Indeed, it is intentional. It is a condensation bleed hole. Now put the cans back on the bike, stop worrying and go riding :beer
-
Finally, I knew the answer to one. :runyay :rockon
-
They're safety valves to prevent the build up of gases in the silencer compartment.... :fp