OzSTOC

Honda ST1100 Section => Honda ST1100 General Questions => Topic started by: Grumpy on October 15, 2015, 01:21:52 PM

Title: ST1100 parts possibility
Post by: Grumpy on October 15, 2015, 01:21:52 PM

Just a hypothetical at this stage.

I would like to know how much interest there would be in the parts from a whole 1100, if it were to be parted out. The only parts not available would probably be the LH fairings and pocket unit. All other parts would be available, including solo seat set up, custom rack and dual seat among other custom bits.

Not definite, but will not even think about it if not enough interest for all parts.

Let me know if interested.

Title: Re: ST1100 parts possibility
Post by: Biggles on October 15, 2015, 01:46:07 PM

Let's say you could get $3000 for the bike as a going concern.
It would take a lot of hassling and a lot of sales to get $3000 in parts.
I'd say keep it running rather than dismembering it, unless there are other issues than the LH fairing.

Title: Re: ST1100 parts possibility
Post by: WendyL on October 15, 2015, 01:57:17 PM

I could be interested in single seat, top box and screen depending on condition and price.

Title: Re: ST1100 parts possibility
Post by: alans1100 on October 15, 2015, 02:04:19 PM

I couldn't use any of the coloured panels but the RH fairing pocket/filler panel I could use (unless I fix the crack in mine). The reserve fuel sender (attached to fuel pump) I would take. Nothing else comes to mind.

Title: Re: ST1100 parts possibility
Post by: spanner on October 15, 2015, 02:05:20 PM

I want the little itty-bitty cover that goes on the left side grey bit ..... you know .... the bit where it covers the hole.

:)     ;-*

Title: Re: ST1100 parts possibility
Post by: spanner on October 15, 2015, 02:06:04 PM

oh .... if the water pump was in good nick I'd prob be interested.

Title: Re: ST1100 parts possibility
Post by: Grumpy on October 15, 2015, 02:18:08 PM

Interesting responses.

Water pump is brand new, but would stay with the engine anyway.

You may be right Biggles, just checking the possibilities at this stage.

I have the chance at a 1300 in silver and I know the bike, so the 1100 would have to go. I have been riding the 1300 lately and it seems to suit me better and is much easier to deal with than the 1100 for some reason.

Oh well, will wait and see if there are any more responses and decide. One thing is for sure, nothing will happen until after harvest (about mid-november).

Thanks

Title: Re: ST1100 parts possibility
Post by: Aj1300 on October 15, 2015, 06:46:18 PM

Grumpy,
I would be interested in the rolling chassis.
Cheers Aj

Title: Re: ST1100 parts possibility
Post by: Jglan10 (Onesie) on October 15, 2015, 10:29:24 PM

At the right price I'll take it

Title: Re: ST1100 parts possibility
Post by: Grumpy on October 16, 2015, 09:27:05 AM

Quote from: Jglan10 (Onesie) on October 15, 2015, 10:29:24 PM

At the right price I'll take it

You better PM me a price and we'll see if we agree   :wink1

Title: Re: ST1100 parts possibility
Post by: NTRebel on October 25, 2015, 09:34:52 PM

I could be interested in rear caliper and rear master cylinder.