OzSTOC

Honda ST1100 Section => Honda ST1100 General Questions => Topic started by: spudwa on February 20, 2025, 03:22:40 PM

Title: Sidestand hitting exhaust pipe
Post by: spudwa on February 20, 2025, 03:22:40 PM

While refitting the belly pan I noticed that the sidestand is resting against the exhaust pipe rather than the rubber stop. Can I take the sidestand off and belt it with a hammer?

Title: Re: Sidestand hitting exhaust pipe
Post by: Phil on February 22, 2025, 10:59:33 AM

I think the side stand is cast so belting it with a hammer may not be such a good idea. I'd investigate the cause of why it's missing the bump stop. Bracket bent? something else out of alignment?

My 2 bob for what it's worth

Title: Re: Sidestand hitting exhaust pipe
Post by: Joso on February 22, 2025, 03:49:35 PM

Mine is the same

Title: Re: Sidestand hitting exhaust pipe
Post by: Phil on February 23, 2025, 03:25:42 PM

My ST11 is all over the workshop floor ATM. I'll see if I can get a decent photo of how my sidestand sits and potential reasons for lack of alignment