OzSTOC

General Category => General Discussion => Topic started by: Bikebear on October 13, 2012, 03:22:01 PM

Title: Resin badges
Post by: Bikebear on October 13, 2012, 03:22:01 PM

Not STrictly ST related but when we bought the GIVI cases for the Missus' DN01 they came with different badges on either side. This didn't worry the missus but it annoyed me, so I did a bit of searching and found a mob in the UK who would do one off resin badges to order. I went to their website http://www.domedbadge.co.uk/ (http://www.domedbadge.co.uk/) and ordered a couple of chrome on black Honda badges to fit where the Givi badges were, here's the result..

(http://i93.photobucket.com/albums/l44/Bikebear/Hondabadge.jpg)

I reckon they look pretty good and they only cost about $30 bucks, which I reckon for a one off order from pommy land wasn't bad.

Title: Re: Resin badges
Post by: Brock on October 13, 2012, 03:30:36 PM

 :thumb :thumb

Title: Re: Resin badges
Post by: West Aussie Glen on October 13, 2012, 03:45:56 PM

Very Nice

Title: Re: Resin badges
Post by: Brian on October 13, 2012, 05:10:59 PM

I can feel a couple of ST1800 badges commin on

Title: Re: Resin badges
Post by: Whizz on October 13, 2012, 05:17:32 PM

Mate, they look GOOODDD!! Nice job!

 :-++ :-++

Title: Re: Resin badges
Post by: Abe on October 13, 2012, 06:41:33 PM

Bikebear, we may be distant brothers,  I"m trying to seal/glue the logo cut from an Ozstoc business card into the centre of my oil cap, so resin badges is a timely topic.

Cheers
Dave