OzSTOC
Honda ST1300 Section => Electrics & Electronics - Volts, Amps and Fuses ST1300 => Topic started by: HunterTodd on June 30, 2014, 07:18:10 PM
-
Hi All,
After an humiliating moment where I had to be push started by some of my Harley mates after leaving my heated hand grips on and flattening the battery I have finally put a relay in.
The only thing is despite sticking my probe anywhere it will fit I can't find a wire that comes live when the ignition is turned on to switch the relay. I would like one near the battery but failing that anywhere on the bike would do.
Any suggestions Tech heads?
-
Easy.
Use the quartet harness to supply all sorts of power options. There is a 9pin socket on the left side low down, in a plastic shield. Probaly full of dielectric grease.
-
Well there you go I only looked on the right hand side of the bike. Will I have to remove plastic to get to it?
-
Yep you do.I'm not sure exactly where it is, but some one will show up with a pic soon. Have a look in the quartet harness thrread. its a sticky thread 2 or 3 above this one in the electrics area (1300)
-
here you go, read through all the pdf docs
http://www.st-owners.com/forums/showthread.php?7714-ST1300-Quartet-Harness-Installation (http://www.st-owners.com/forums/showthread.php?7714-ST1300-Quartet-Harness-Installation)
enjoy
-
Multiple 12V accessory pick up points on the Left side at the relays..... :like