OzSTOC
General Category => General Discussion => Topic started by: Greencan on November 04, 2014, 08:18:33 PM
-
Wanna see 2 idiots...1 working machinery and 1 makin' a move :well...
https://www.youtube.com/watch?v=7I4iREEkbSQ&feature=youtu.be (https://www.youtube.com/watch?v=7I4iREEkbSQ&feature=youtu.be)
...or how to really stuff an ST1100 rear wheel ++
Courtesy of Saaz n Greencan :grin
-
LOL
-
Does the long haired bloke know what he's doing?
-
Nice pile of of swarfe ya got there Dickie....
Laurie
-
Nice pile of of swarfe ya got there Dickie....
Laurie
Should return better fuel figures now that it 3 pounds lighter :Stirpot
:beer
-
I can only see one....... :eek..............................that sounded better in my head. :grin............. :wht11 o:)
-
Does the long haired bloke know what he's doing?
Crickey Bill, I am nearly bald as a badgers bum :whistle...Heck! I had to fork out...(hang about, best not say how much as the Hubby of the girl who's been annually cuttin' me hair might well read this :wink1), getting most of it cut off while up on the Coast!
The only thing I regret in not working these days, I could have claimed the travel cost for the hair cuts on tax before :eek.
Bill, the greencan moto for experimental engineering is: begin on someone else's bike ;-... so the short answer would be NO!
Quote from: laurie on November 05, 2014, 11:20:52 AM
Nice pile of of swarfe ya got there Dickie....
Laurie
Should return better fuel figures now that it 3 pounds lighter :Stirpot
...Yep, have been learning to turn solid bits of metal into piles of swarfe, ever since they decided to take me needles, syringes and Dx off of me :-(((
Watta ya think of the cameraman? Reckon he makes a better bearBeer taster... :beer
cheers the can :-)
-
The cameraman is judged competent, not sure about the machinist though.....
Laurie
-
Except I did not have the iPhone around the right way for videos so some editing was required :|||| It was worth hanging around to see that part of the milling first hand, so getting back home a bit later was worth it. The skill and experience, not of Dick but Jim the master and owner of the milling machine, was something you cannot learn from books or videos. Jim is just 89 so a few years left to learn some things for young Dick.
-
The skill and experience, not of Dick but Jim the master and owner of the milling machine, was something you cannot learn from books or videos. Jim is just 89 so a few years left to learn some things for young Dick.
Thanks for that glowing endorsement John!
So with that I will bid you all farewell in your ST endevours, I know when to take a hint and leave well alone.
greencan signing off for the last time.
-
The skill and experience, not of Dick but Jim the master and owner of the milling machine, was something you cannot learn from books or videos. Jim is just 89 so a few years left to learn some things for young Dick.
Thanks for that glowing endorsement John!
So with that I will bid you all farewell in your ST endevours, I know when to take a hint and leave well alone.
greencan signing off for the last time.
Aww Can. Bring back your bat and ball. Remember, you started this! I'll speak to John.