OzSTOC

Honda ST1100 Section => Electrics & Electronics - Volts, Amps and Fuses ST1100 => Topic started by: Kev on February 23, 2012, 04:41:53 PM

Title: Neutral Switch
Post by: Kev on February 23, 2012, 04:41:53 PM

Can anyone point me in the direction for the neutral switch?...I need to tap into a wire

Thanks and Cheers  :beer

Kev

Title: Re: Neutral Switch
Post by: saaz on February 23, 2012, 05:05:34 PM

Supposedly it is on the left hand side of the transmission casing on the back of the engine. It screws into the casing. You can just pull off the wire as it has a connector.

Title: Re: Neutral Switch
Post by: Brock on February 23, 2012, 06:50:23 PM

What are you looking at doing Kev?? There may be an rasier way.

Title: Re: Neutral Switch
Post by: Brock on February 23, 2012, 07:15:30 PM

I will have a look at the circuit, and look for a good place to connect in.

Title: Re: Neutral Switch
Post by: Brock on February 25, 2012, 10:51:50 AM

If you need a 3pin connector, let me know I should have a matching pair. I could even knock up a small harness with a long fly lead that you can then patch to the indicator. I am not a fan of cutting into wires if it can be avoided.

I will pull the left cover off tomorrow and check out the wiring config.

Title: Re: Neutral Switch
Post by: Brock on February 26, 2012, 07:56:31 PM

This should do the trick Kev, if you email me your address I will send it over.

(http://img.photobucket.com/albums/v235/Avtrician/Misc%20Photos/Neutral_Adapter.jpg)