OzSTOC
General Category => General Discussion => Topic started by: curious1 on February 12, 2015, 06:46:35 PM
-
I came across some old topic about the install of heated grips and the fun/pain of putting the plastic bits back on. Just did this job to my NC and had the same problem and more. Not only having a lot of difficulties to do job which needs 3 hands with only 2 I am left with 4 screws and can't find a hole where to put them. Since this is a ST. forum I can't hope to find advice where this screws will fit but whatever bike you worke on TAKE Pictures while you go. I still live and learn but getting a bit to old for the hassles.
-
Diesel made up printable sheets to put all the fasteners off the ST13 on as they come off the bike.
That makes it a lot easier and quicker when you'r reassembling it all.
You could make a set for your "NC".
I use patty cake trays. :grin
Where did you hide those diagram thingies, Diesel Dave?
-
Done it for him Brock :wink1
http://ozstoc.com/index.php?topic=18.0 (http://ozstoc.com/index.php?topic=18.0)