« previous next »
Pages: [1]   Go Down

Author Topic: ST1300 head bearing  (Read 3061 times)

Richard Court

  • Guest
ST1300 head bearing
« on: November 05, 2013, 03:06:36 AM »
 :candystwheelie
I had a new genuine Honda bearing fitted to my 2003 ST1300 about a year ago.  Since then my bike has developed an annoying  front end rattle.  Last week I had the bike serviced and asked the mechanic to rectify the problem which he did by tightening it.  After a short test ride all seemed fine and smooth but then I went for a 400 Kl run on the weekend and on the way home the rattle started to manifest itself once again.  Has anyone else had this problem and  can give me a solution'
when I travel over a rough section of road I hear a "CLUNK CLUNK RATTLE RATTLE RATTLE" :beer
« Last Edit: November 05, 2013, 03:10:19 AM by Richard Court »
Logged
 

Paul

  • Guest
Re: ST1300 head bearing
« Reply #1 on: November 05, 2013, 07:29:35 AM »
 :-[  :eek It sounds like the bearings weren't seat correctly the first time they were fitted, this has happened to me with a previous bike.
I had to adjust  the bearing tension at least twice before they seated properly.  :thumb

 :blu13
Logged
 

saaz

  • Guest
Re: ST1300 head bearing
« Reply #2 on: November 05, 2013, 11:32:24 AM »
Agree with that. bearing races need to be installed and driven all the way in, then torqued up correctly.  Adjusting it a few times should do the trick.
Logged
 

Richard Court

  • Guest
Re: ST1300 head bearing
« Reply #3 on: November 05, 2013, 01:11:34 PM »
 :candystwheelie
Thanks so much guys for your helpful and speedy answers.  I will give it another try. :beer
Logged
 
Pages: [1]   Go Up
« previous next »