Author Topic: Throttle Clamp (Read 1599 times)

Marcus · « **on:** April 28, 2012, 03:32:24 PM »

Hey guys I just got a throttle clamp/lock and decided to instal it today.

But after following the instructions I've found that it won't fit between the cables as per instructions.

So before I start modifying it with my trusty hacksaw. Has anyone else got it to fit?

Whizz · « **Reply #1 on:** April 28, 2012, 03:58:39 PM »

Hey Marcus, is this where the trusty hacksaw comes into its own?

bobSTer · « **Reply #2 on:** April 28, 2012, 04:29:34 PM »

Kev,

I have fitted similar - the instructions state to "FILE" lightly & evenly on each side until a firm fit is achieved.
I did this & whooppee - it works - I may have taken a little too much but it works, with slight movement.
Remember - a File.

Good luck

Bob

JuST Peter · « **Reply #3 on:** April 28, 2012, 04:31:17 PM »

I had the same type on my 900 Hornet, and had to cut it down with said hacksaw (or file) to make it fit between the cables. Actually I think I used the bench grinder.
It worked like a charm and did so for many years :)

pault · « **Reply #4 on:** April 28, 2012, 07:01:59 PM »

my st came with a nep which the previous owner said did not work. a bit of fiddleing with the adjust screw and it works fine, happy with it and would recommend same, cheap and easy.

News:

Author Topic: Throttle Clamp (Read 1599 times)

Marcus

Throttle Clamp

Whizz

Re: Throttle Clamp

bobSTer

Re: Throttle Clamp

JuST Peter

Re: Throttle Clamp

pault

Re: Throttle Clamp