Honda ST1300 Section > Brakes & Clutch ST1300

brakes with a mind of their own

<< < (2/2)

Biggles:

--- Quote from: troy_s on May 09, 2019, 04:58:07 PM ---Hi Biggles,
 This sounds like a winner.
 How would I check this?

--- End quote ---

Like Alan says, check the integrity of the sensor disk (secure, no warps), then the mounting of the sensor and finally the gap (approximately 2mm).  Ensure there is no foreign material in the gap- that the face of the sensor is clean (it's magnetic and can collect iron particles). If all those external items are in place it gets technical.  Pages 23-10 to 23-16 in the Manual describe the system but there is no trouble-shooting associated with it there or in the Addendum.  A read there might provide a clue.

Navigation

[0] Message Index

[*] Previous page