Several weeks ago I noticed that the LH trailer lens had a missing piece and it was in an area where the least damage (if any) would occur. This was an LED set that I installed in 2011 since the OEM light lenses were all cracked and the globe and wiring contacts parted company at times. For an LED set the lights weren't that bright but passable at night so the lens breakage helped with the decision to get a better set.
Finding the right LED set was an issue as I wanted to keep close to the OEM Light sizes and include the plate light on both sides. The lights were found at a wholesaler which meant a shop had to get them in for me. Our local hardware shop was the right place so I could get them in with their usual order and the freight cost would be minimised. The set cost $128 (not cheap) and ADR compliant so the lights have to meet minimum standards at least.
I picked then about a week ago and fitted today after all the rain went and it was still cool enough outside.
Took this the day I got them.
Today:-
First up is to remove the installed set and 4 bolts on each light. This was how the OEM light were also done and I used the same holes but replaced the bolts.
The old LED and OEM lights look identical and the lenses could be used on both. The lenses has to be removed and the wiring parted so the light fitting can be removed.
The broken LH lens. This is the bottom and sits almost flush with bumper as you can see in the above picture.
The new mounting plate in place. A simple matter of feeding the trailer wiring through the hole I the plate and replacing the old bolts etc. One hole lined up (on both sides) and I drilled the other three to suit the holes in the mounting plate.
New lights ready for soldering bit which I'm not to good at but the solder from the last was still solid so must have done something right.
Four wires soldered and electrical tape to keep them apart. For extra support I taped the wires together at the join before fitting the lights.
The testing phase. Hook the trailer wiring into the bike and amazingly it still works. I did the LH first to compare to the RH and you can clearly see the difference. I fitted the LED clearance lights just after I bought the trailer in January 2011.
We also made up our own Ozstoc stickers for the trailer so who said printer ink doesn't last.......lol
The completed job. All lights work and the trailer is ready for it's next trip.
I added the reflectors a few months back as none of the previous light sets had any included but the new LED set do.