OzSTOC
Farkles, Gear & Accessories => Lights and Lighting => Topic started by: Simmo50 on April 07, 2017, 09:54:57 AM
-
Hi is there anyone in the perth area that would have a spare hour to connect some rear lights and possibly front strobes To the switches on right handle bar of my st1100.
Been trying for over a week to figure it out. Have a rear fuse box and earth box already fitted in rear pod. Thanks
-
Its not too hard, here is a circuit I drew up to use the 1,2 switch. ignore the relay bit.
Actual connections may change depending on the strobes used.
https://www.dropbox.com/s/oowj1fqq0rubmhg/Strobe%20Circuit.pdf?dl=0 (https://www.dropbox.com/s/oowj1fqq0rubmhg/Strobe%20Circuit.pdf?dl=0)
-
Thanks for that. But I've seen this. Before and still can't figure it out. I'm using a el13strobe unit for the rear lights. People have tried to explain it to me but can't do it.
-
Aha,
is it a flasher can or a relay, what sort of lights are you using
-
The lights are the standard original rear red lights. Not striving. I have a separate unit that controls the strobing .
effect.
Have the lights connected to this. But need to know how to get it working through switches.
-
OK,
So you need to switch power to the strobe control unit via the Switch grip using Sw 1, You have connections from the strobe unit to the light heads..
Do I read that correctly, what type of strobe controller are you using, having the wiring diagram will help.
I think I have a spare 9 pin plug for the switch jarness in my parts box, I can make up the connection harness easily.
-
Are you free at all in the morning to have a quick look at it for me . Would be a lot easier with that 9pin plug when i do the other lights also
-
Not free today, but will be tomorrow.