Honda ST1300 Section > Electrics & Electronics - Volts, Amps and Fuses ST1300
Speed cable
(1/1)
WallyD:
Hi guys. I’ve purchased a Commander cruise control system which should arrive in a few days. Question is, which cable do I splice into to receive the speed pulse???
Thanks in advance
Sent from my iPhone using Tapatalk
Brock:
Quite a few have mounted a sensor near the rear wheel, and put little high strength magnets in the disc bolt holes.
WallyD:
Yeah, that’s for the non electronic speedo signal.... I’m sure my 2008 has an electronic signal.... just need to find out where I can pick this up from.....
I’m actually 100% sure it’s electronic, as there is no speedo cable (mechanical cable) going into the back of the speedo itself
Sent from my iPhone using Tapatalk
Brock:
The speed pulse will come from the speed sensor that lives near the rear left of the engine I think. You would need to be very careful in how you tap in, to prevent damage to the wire or the system.
Navigation
[0] Message Index
Go to full version