Honda ST1300 Section > "How To..." Instructions and Pics for Regular Maintenance Jobs specific to the ST1300...
FINAL DRIVE OIL CHANGE
Shiney:
FINAL DRIVE OIL CHANGE As demonstrated by Diesel :thumbsup
This should be done every 10000 to 16000 kms
Place oil tray (or ice cream bucket) down to catch oil and remove lower bolt
NOTE: Before removal of the bolt make sure the large cap above and to the rear can be undone
Remove the large cap above and to the rear of the previously removed bolt and place a tube on the new container of final drive oil
Replace bottom bolt and torque it to 14lbs. (Replace crush washer too if required.) Pour the new oil in where the large cap was until the oil is all the way up to the hole then replace the cap.
Gadget:
:thumbs
alans1100:
This will for the 1100 as well but every 30,000 km for the oil change time.
Brock:
--- Quote ---This will for the 1100 as well but every 30,000 km for the oil change time.
--- End quote ---
30000Ks or so that is
STroppy:
I would only add that before you undo any drain plugs I would loosen the filler plug, just in case you find the little bugger is bloody tight and you may need to relocate the bike to a workshop . . Not good to ride it without any oil in it . .
Navigation
[0] Message Index
[#] Next page
Go to full version