Hi all
Thank you for allowing me to post in here. As I get time I will add more information about the products and services offered by PM Lubricants.
Simply- All of PM Lubricant's products are built to the highest quality standard. The key- is building the highest load carrying ability, or film strength, which reduces friction and has flow on effects, such as increased power, better economy, reduced wear and reduced vibrations.
PM Lubricants oils range from 10w40 to 25w60, most except Racing 50 is priced around $12 per litre, product codes as follows:
PM412LA- SAE 10w40- a full Group IV synthetic currently being run very successfully in F3 to race bikes. Designed for 2 reasons- firstly to fill the need of manufacturers specifying low viscosity synthetics, secondly as a Low Ash oil capable of being run in Commonrail Diesels with particulate filters.
PM412 SAE15w40. The bread and butter oil for years- proven in almost all forms of racing and some of the toughest prime movers in Australia, again currently being used in motorcycle racing. This is what I run in almost all of my machines with noticeable power improvements, reduced vibrations and wear rates halved in oil analysis. 40,000km changes in good, clean petrol passenger vehicles, 60,000km or more in diesels, well over 100,000km in transport. I expect upwards of 24,000km changes in ST's.
PM403 SAE 20w50. Well proven and standard issue for air cooled, ageing vehicles from mid to late 90's and older, or those showing a little wear.
PM408 SAE 25w60. Commercial variant of Racing 50. For older worn engines, cure notchy gearchanges, large bore, tough oil which has surprised many with it's ability to increase power even with heavier viscosity.
PM404 Racing 50. SAE 25w60. The toughest oil available. I will gladly and openly pit it against ANY oil available. Racing 50 is becoming more and more famous amongst the guys who drive/ ride hard enough to justify using this oil. Season after season with no measurable wear. Unsurpassed film strength- power increases even for such a heavy oil.
This is not a complete list, but rather the oils that will be most used on here.
All oils come with PM Lubricant's free testing service- we don't want extended oil drains without the chance to test and make sure your engine is as it should be. By all means, we have no issue with you changing at your current intervals, but once you use our products you may change your mind.
Contact myself, or our distributors on
http://pmlubricants.com.au/Brad
0406 766 106