Hi guys,
I thought I make note of this here has I have just been experiencing a similar issue after replacing the rear brake pads.
I replaced the rear brake pads with new Metal Gear ones and after using the rear brake for the first time my rear wheel wasn't spinning freely anymore.
With the bike on the centre stand I could spin the wheel by hand however as soon as I let go it would stop almost instantly.
I took the bike for a run thinking that maybe I just needed to bed in the pads but when I got back the disc was sizzling hot and the issue remained.
I did a lot of reading and diagnostics before I figured out the issue.
When I had replaced the standard Honda pads with Metal Gear pads I had reinstalled the metal plate that sits at the back of the standard Honda brake pads to the back of the new pads.
Anyway after removing this metal plate from back of both pads the brakes now operate normally, stopping the wheel from moving and then releasing allowing the wheel to spin freely.
So if you are doing a brake pad change DON'T reinstall the metal plates pictured below.
Cheers
Shiney
Sent from my SM-G950F using Tapatalk