Author Topic: CNC Valve Stems  (Read 86 times)

Online alans1100

  • 1999 ST1100A
  • RTE Coordinator
  • UNBELIEVABLE "5000 Posts" Member
  • *
  • Posts: 6118
  • Thanked: 1077 times
  • Alan, Peterborough, SA
CNC Valve Stems
« on: July 24, 2019, 02:28:34 PM »
I ordered some right angle valve stems a few weeks ago and they arrived today.

Total cost for both bikes was $12.68 via an eBay Chinese seller. I did check some of the local sellers and they all had the same but at a higher price.

Red for the 1300A and Blue for the 1100A



1999 :bl11  2004 :13Candy

FarRider #921- BR15, BR17, CR1

 

Offline richo

  • Richo
  • Legendary Member
  • *****
  • Posts: 709
  • Thanked: 247 times
  • ST 2009
Re: CNC Valve Stems
« Reply #1 on: July 24, 2019, 05:13:03 PM »
Looks like a good find.  I paid more than that for mine
Richo
 

Online alans1100

  • 1999 ST1100A
  • RTE Coordinator
  • UNBELIEVABLE "5000 Posts" Member
  • *
  • Posts: 6118
  • Thanked: 1077 times
  • Alan, Peterborough, SA
Re: CNC Valve Stems
« Reply #2 on: July 24, 2019, 05:48:29 PM »
It is a good find but when I went to the shop I stopped off at the tyre dealer and though they are okay it is better if the rubber seal was on both sides.

With that in mind I've found some more in Australia that are better in the sealing area. https://www.ebay.com.au/itm/163680746203?

Not a total loss as the pictured ones can go on the bike and car trailers or I can resell them at cost plus postage.
1999 :bl11  2004 :13Candy

FarRider #921- BR15, BR17, CR1

 

Offline richo

  • Richo
  • Legendary Member
  • *****
  • Posts: 709
  • Thanked: 247 times
  • ST 2009
Re: CNC Valve Stems
« Reply #3 on: July 24, 2019, 05:56:52 PM »
I will have to store the handy information about the seals on both sides for when I have to replace mine at some stage
Richo